Peppermint Chocolate Layer Cake

Step 1

Preheat oven to 350°F (177°C). Position rack in the middle of the oven. Grease and line a 9 x 3 inch deep round cake pan with a circle of parchment. Use cocoa powder instead of flour to coat the sides of the greased cake pan.

Step 2

In a large bowl whisk together the all-purpose flour, cocoa powder, baking powder, baking soda, and salt until no lumps remain. Set aside.

Step 3

In the bowl of a stand mixer, using the paddle attachment, cream together the Redpath® Dark Brown Sugar, melted butter, and vegetable oil until combined; 2 minutes. Add in the eggs one at a time, fully incorporating each egg before adding the next one. Mix in the vanilla extract.

Step 4

In a microwaveable bowl or measuring cup, heat 2/3 cup (160 ml) of the milk until hot. Stir and dissolve the instant espresso into the hot milk.

Step 5

On low speed, add 1/3 of the dry ingredients into the batter, mixing until just combined. Add in the remaining 2/3 cup (160 ml) milk and mix until combined. Repeat process with the remaining flour and the warm espresso-milk mixture, ending with the dry ingredients; do not overmix.

Step 6

Pour and evenly smooth out the chocolate batter into the prepared cake pan. Place into the preheated oven. Bake for 55 to 60 minutes or until a skewer inserted into the centre of the cake comes out clean.

Step 7

Let cake cool slightly in the pan; 10 minutes. Carefully run an offset spatula or a small paring knife around the cake. Invert cake and set right side up to cool completely on a wire cooling rack.

Step 1

Make the Quick Buttercream as directed. Add the salt when creaming the butter. Mix in the peppermint extract when adding the vanilla extract.

Step 1

With a sharp, serrated knife, slice off the rounded top of the completely cooled or chilled cake, creating a level surface.

Step 2

With a steady hand, slice the chocolate cake in half. Carefully remove the top layer.

Step 3

Transfer some of the peppermint buttercream into a piping bag fitted with a large round piping tip.

Step 4

Place the bottom layer onto a plate or turntable. Starting from the centre, pipe buttercream in concentric circles onto the cake layer. Pipe a second layer of buttercream over the first layer. Smooth cream with an offset spatula. Place the top layer onto the piped buttercream, gently pressing down.

Step 5

Spread a thin layer of the peppermint buttercream onto the top and sides of the cake; this is the crumb coat.

Step 6

Place into fridge to set up; about 15 minutes. Evenly spread the remaining buttercream onto the tops and sides of the cake.

Step 7

Decorate the sides and top of the cake with the crushed candy canes or peppermint candies.